Stamping stamping equipment (mainly Press) on the mold to put pressure on the material to produce plastic deformation or separation, to obtain the necessary parts (commonly known as stamping or stamping) a pressure processing method. The st... ...More>>
First, the jaw crusher feed, should be required to run half an hour, observe whether the operation is good, there is no noise, after all normal before breaking work. Moreover, the primary feeding should be small grained gravel or all finish... ...More>>
Main types of crushing machines: In accordance with the structure and working principle of the difference, the commonly used crushing machinery has the following types: (1) the jaw crusher depends on the movable jaw plate for periodic recip... ...More>>
One,A proper use of dredging boat 1, before starting the first of the entire mechanical drive system and machine oil checked, and then start the pull back conveying diesel engine, with the pull clutch, start engine, slowly moving loose clut... ...More>>
Ball is the material being broken, and then smash the key equipment. It is widely used in cement, silicate products, new building materials, chemical fertilizer, non-ferrous metal processing, such as glass ceramics industry production of al... ...More>>
Most of the material is made of high chromium wear-resistant cast iron, high chromium cast iron has good flow, larger shrinkage, large tendency to crack, so it can extend the service life of hammer head and lining board 1, the casting proce... ...More>>